This gas cap holder stops your fuel cap from hanging and scratching your paint every time you fill up. It's a 3D-printed ASA holder with an OEM+ fit that mounts to your fuel door and gives the cap a secure spot to sit, instead of dangling against your bodywork. The new and improved design fits every Mitsubishi DSM and 4–6 generation Lancer Evolution.
Printed in ASA, it won't crack, warp, or break down over time the way brittle plastics do — it shrugs off the heat and sun where it sits on the fuel door. Install takes under 30 seconds with no tools: peel the strip(s) off the pre-applied double-sided tape, line it up, and press it onto your gas door. Tape is included. Designed and 3D printed in-house in Los Angeles.
Confirmed fitment runs across the DSM lineup — Mitsubishi Eclipse, Eagle Talon, and Plymouth Laser — plus the Mitsubishi 3000GT and Lancer Evolution 4, 5, and 6 (CN9A/CP9A). One important note: this does not fit the Evo 7–9.
Details
Fits: Mitsubishi DSM (Eclipse, Eagle Talon, Plymouth Laser), Mitsubishi 3000GT, and Lancer Evolution 4–6 (CN9A/CP9A, 1996–2001)
Does NOT fit: Lancer Evolution 7–9 (CT9A)
Fixes: a gas cap that hangs loose and scratches your paint while fueling
Material: ASA — won't crack, warp, or break; heat- and UV-resistant
Fit: OEM+, new and improved design
Install: tool-free adhesive mount, under 30 seconds; double-sided tape included
Stop letting your gas cap chip away at your paint. Peel, stick, done — and never think about it again.
This gas cap holder stops your fuel cap from hanging and scratching your paint every time you fill up. It's a 3D-printed ASA holder with an OEM+ fit that mounts to your fuel door and gives the cap a secure spot to sit, instead of dangling against your bodywork. The new and improved design fits every Mitsubishi DSM and 4–6 generation Lancer Evolution.
Printed in ASA, it won't crack, warp, or break down over time the way brittle plastics do — it shrugs off the heat and sun where it sits on the fuel door. Install takes under 30 seconds with no tools: peel the strip(s) off the pre-applied double-sided tape, line it up, and press it onto your gas door. Tape is included. Designed and 3D printed in-house in Los Angeles.
Confirmed fitment runs across the DSM lineup — Mitsubishi Eclipse, Eagle Talon, and Plymouth Laser — plus the Mitsubishi 3000GT and Lancer Evolution 4, 5, and 6 (CN9A/CP9A). One important note: this does not fit the Evo 7–9.
Details
Fits: Mitsubishi DSM (Eclipse, Eagle Talon, Plymouth Laser), Mitsubishi 3000GT, and Lancer Evolution 4–6 (CN9A/CP9A, 1996–2001)
Does NOT fit: Lancer Evolution 7–9 (CT9A)
Fixes: a gas cap that hangs loose and scratches your paint while fueling
Material: ASA — won't crack, warp, or break; heat- and UV-resistant
Fit: OEM+, new and improved design
Install: tool-free adhesive mount, under 30 seconds; double-sided tape included
Stop letting your gas cap chip away at your paint. Peel, stick, done — and never think about it again.
